Adhesives

P-70™ PRIMER

P-70™ PRIMER - Industrial Grade

600™ Contact Adhesive

719™ PVC - Contact Adhesive - Industrial Grade

SUREBOND SB-190

Adhesives

WELD-ON® P-70™ Primer
Premium industrial strength primer for softening and preparation of PVC and CPVC pipe and fitting surfaces. Specially recommended for Schedule 80 and large size pipe.

EXTREMELY FLAMMABLE. VAPOR HARMFUL. MAY BE HARMFUL IF SWALLOWED. MAY IRRITATE SKIN OR EYES. READ CAUTIONS CAREFULLY.

DIRECTIONS:
Store below 110 F. Use only on PVC and CPVC plastic. Use within 3 years of date stamped on bottom of can. Read IPS Installation Guide, Product Bulletin and MSDS.

Cut pipe square and deburr.

Clean and dry joining surfaces.

Check dry fit.

Fitting should go over end of pipe easily but become tight about 1/3 to 2/3 of the way on.

Use a suitable applicator at least 1/2 the size of the pipe diameter; for larger sizes use a swab or roller.

Do not use a rag as repeated contact with skin may cause irritation or blistering.

Apply primer to inside of fitting equal to socket depth; without delay coat pipe end up to socket depth until soft.

Apply again to fitting socket.

Avoid puddling.

On bell end of pipe, do not coat or allow primer to run beyond socket depth.

To check penetration, scratch surface.

Re-coat if necessary. Actual time for priming action is affected by pipe diameter and temperature.

Immediately while surfaces are still wet, apply appropriate WELD-ON REG cement following directions on cement can.